View Product Page

This Quick Start Guide covers setup of the Satechi Slim X2 Bluetooth Backlit Keyboard (ST-BTSX2M): powering on the keyboard, pairing up to four devices over Bluetooth, sleep and wake, recharging, wired mode, and swapping the media and function keys.

Setup steps:

Step 1: To turn on the keyboard, move the switch on the top of the keyboard to the "on" position.

The power indicator light should turn green for ~3 seconds, then turn off

Step 2: Press and hold one of the keyboard's Bluetooth keys for ~3 seconds, until the LED light starts to blink.

Select "Slim X2 Keyboard" on the host device’s Bluetooth settings to complete the pairing process.

Repeat for each button to connect up to four devices

Step 3: After 30 minutes of inactivity, the keyboard will go into sleep mode to preserve battery.

Press any key to wake and the keyboard will automatically connect.

Step 4: To recharge, connect the keyboard to a powered USB-C port using the included cable. Charge for 2-3 hours or until the red charging light turns green.

Power indicator light will flash green when on low battery

Step 5: The keyboard can be used in wired mode by pressing "Fn + Eject" while the cable is connected.

Press the Bluetooth keys to switch back to wireless mode

Step 6: Press "Fn + Esc" to swap between Media and Fn keys.