View Product Page

This Quick Start Guide covers setup of the Satechi 200W USB-C 6-Port PD GaN Charger (ST-C200GM-US): connecting the power cable, positioning the charger flat or upright, charging up to six USB-C devices, and the power output per port.

Setup steps:

Step 1: Connect the included C5 power cable to the C5 connector on the rear of the charger.

Step 2: Plug the power cable directly to a power outlet.

Step 3: The LED Indicator light will Illuminate white when receiving power.

Step 4: The 200W charger can be laid flat horizontally on the supported rubber feet or vertically using the included Desktop Stand.

Step 5: Plug in cables (sold separately) to the charger's USB-C PD ports.

We always recommend using certified charging cables.

EMARK cables are required to reach wattage above 60W.

Step 6: Connect and charge up to six USB-C devices simultaneously

Total max output: 200W.

When connecting devices to all six PD ports, connect your largest device to the PD1 port.

Charging:

Step 7: When connected to PD1 or PD2, supported device can charge with a max output of 140W.

Only one device can be connected at a time to either port in order to achieve 140W charging.

USB-C to MagSafe 3 Cable must be used in order to achieve 140W output through PD1 or PD2.

Step 8: When connected to PD3 or PD4, supported device can charge with a max output of 100W.

Step 9: When connected to PD5 or PD6, supported device can charge with a max output of 20W.

Note: Please refer to the Power Schematic in the user manual for actual power outputs, depending on the number of connected devices