View Product Page

This Quick Start Guide covers setup of the Satechi 145W USB-C 4-Port GaN Travel Charger (ST-W145GTM): replacing the regional outlet adapter and charging up to four USB-C devices, with the power output across single, dual, triple, and four-port connections.

Replacing outlet adapter:

Step 1: To disconnect the attached outlet adapter slide the switch on the top of the device away from the connector.

Step 2: Slide the released outlet adapter up.

Step 3: Choose the compatible outlet adapter for your region and slide it into place.

Charging your devices:

Step 1: Plug in cables (sold separately) to charger’s USB-C PD ports.

Step 2: Connect and charge up to four USB-C devices at a time.

Total max output is 145W

Step 3: Single port connection

Step 4: Dual port connection

Step 5: Triple port connection

PD1 & PD2 will adjust power output depending on which port the largest device is connected to

Step 6: Four port connection

Note: PD1 & PD2 ports support PD 3.1 @ 140W. 140W charging speed on PD1 or PD2 ports can be achieved only if single port is in use. Must use compatible MagSafe cable to reach 140W charging speeds.