SSD Installation Guide: DotDisk™ 80Gbps SSD Enclosure

Before You Begin

• Ensure you have a compatible SSD. The enclosure supports only 2280 M.2 NVMe SSDs up to 8TB. It does not support SATA SSDs, 2230, 2242 or 2260 sizes, or SSDs with pre-installed heatsinks.
• Work on a clean, static-free surface.
• Handle the SSD by its edges to avoid static damage.

Installation Steps

• Open the enclosure: Use the included T5 screwdriver to remove the Top Cover Screw (smaller), then lift the top cover off.
• Locate the M.2 slot: Identify the M.2 connector inside the enclosure.
• Insert the SSD: Align the SSD's connector with the M.2 slot. Insert at a 15 to 30 degree angle, then press down flat.
• Secure the SSD: Fasten the SSD Screw (larger) to hold the SSD flat against the slot. Do not overtighten.
• Apply the thermal pad: Peel the plastic film from the thermal pad and press it firmly onto the top surface of the SSD.
• Close the enclosure: Place the top cover back on with all edges aligned, then tighten the Top Cover Screw (smaller) until snug.
• Connect and format: Connect the included Thunderbolt 5 cable to the enclosure's USB4 V2 port and to a Thunderbolt 5, USB4, or USB-C port on your computer. Open Disk Utility (Mac) or Disk Management (Windows) to format the new drive.