View Product Page

This Quick Start Guide covers setup of the Satechi FindAll™ Card (ST-LFAWCK ST-LFAWCW ST-LFAWCR): works with Apple's Find My network to locate your wallet or bag, in a slim card form factor.

Setup steps

Step 1: Charge the Card with a wireless charger (not included). The status light will be orange while charging and green when fully charged.

It is recommended to charge once every 12 months. Battery life lasts up to 16 months* on a single charge (may vary depending on usage).

Step 2: To power on the Card, press the power button once. It will beep to indicate it is on.

If not paired within 10 minutes, it will beep and automatically power off.

Step 3: To power off the Card, quickly press the power button 2 times, then long press the 3rd time for at least 5 to 7 seconds. You will hear two beeps, indicating your FindAll™ Card is powered off.

When device is powered off, you cannot track its location.

Step 4: To pair the Card, open the Find My app, tap Add Item under Items, and tap Other Supported Item. Once “Satechi FindAll™ Card” is detected, tap Connect.

Do not leave the app while pairing the device.

Step 5: To remove the Card, open the Find My app, tap the Card under Items, tap Remove Item, tap Remove, and confirm to remove.

If unable to pair with a new device, a factory reset must be done.

Step 6: To factory reset the Card, quickly press the power button 4 times, then long-press for at least 3 seconds, then you will hear a beep confirming the Card has been reset.