View Product Page

This Quick Start Guide covers setup of the Satechi OntheGo™ Qi2 3-in-1 Wireless Charger (ST-QTG31K ST-QTG31W ST-QTG31R): charges an iPhone, Apple Watch, and AirPods at the same time with Qi2 magnetic wireless charging.

Setup steps

Step 1: Unfold the OntheGo™ 3-in-1 Charger to access the Qi2 (15W), AirPods (5W), and Apple Watch (5W) wireless charging modules.

Step 2: Connect the included USB-C charging cable to a power adapter (not included). A minimum 36W power adapter is required for optimal performance.

Step 3: Plug the USB-C charging cable into the USB-C port on the rear of the charger. The front LED indicator will briefly turn on, turn off, then flash once to indicate that the charger is connected to power.

Step 4: Place a compatible phone on the left Qi2 charging pad. Supports 15W wireless charging.

Step 5: Place wireless charging earbuds on the middle pad to begin charging. The LED indicator will illuminate only when using the middle pad. Supports 5W wireless charging.

Step 6: Place the Apple Watch on the watch module to begin charging. Flip the module up to enable Nightstand Mode. Provides 5W charging for Apple Watch Ultra and Ultra 2. Fast charging supported on Apple Watch Series 7, 8, 9, and 10.

Note: If using a non-MagSafe iPhone, a magnetic attachment or a compatible Qi2/MagSafe case (not included) is required. A minimum 36W power adapter is required for optimal performance.