View Product Page

This Quick Start Guide covers setup of the Satechi OntheGo™ Bluetooth Mouse (ST-MOTGK ST-MOTGW): pairs over Bluetooth for wireless control on the go and recharges over USB-C.

Setup steps

Step 1: Before use, please fully charge the OntheGo™ Bluetooth Mouse via USB-C port using its included cable.

Step 2: Turn on the OntheGo™ Bluetooth Mouse using its backside power switch. Be sure to remove the clear adhesive film from the bottom of the mouse before use.

Step 3: Put the mouse into pairing mode. Press and hold the Bluetooth button for 3-5 seconds. The LED will flash white. You will be able to pair up to three devices.

Step 4: Turn on Bluetooth on your device and select “OntheGo Mouse” from the list. Click “Connect” to finish the connection process.

Step 5: The mouse is equipped with 4 buttons and a scroll wheel. The center button is to control the DPI sensitivity of your cursor that can be set to 800, 1200, 1600, 2400.

Step 6: Press the pairing button to switch between Bluetooth channels (1, 2, or 3). An LED above the active channel will light up to indicate your current connection.