This Quick Start Guide covers the setup of the Satechi OntheGo™ 5-in-1 Multiport Adapter | ST-POTG5SB ST-POTG5SY ST-POTG5SP.

Setup

PLUG & PLAY

1. Connect to a USB-C host device
2. Connect your devices

POWER ON/OFF INDICATOR

• Powering On: White LED
• Powering Off: LED Off

WRAP & SECURE THE CABLE

1. Coil the USB-C cable into the bottom groove of the adapter, following the circular path.
2. Push the USB-C connector into the designated clips to lock it in place.
3. Ensure the cable sits flush and the connector is firmly held to prevent it from coming loose during travel.

ATTACH THE 3M ADHESIVE RING

1. Clean the surface where you'll place the 3M Adhesive Ring.
2. Before peeling the adhesive, check that the USB-C cable comfortably reaches your device's port. Adjust placement if needed.
3. Remove the protective film from the 3M Adhesive Ring to expose the adhesive.
4. Press the 3M Adhesive Ring firmly onto a clean, flat surface. Avoid curved or textured areas.
5. Attach the OnTheGo 5-in-1 Adapter and connect your devices.

IMPORTANT

• Magnetic base does not provide wireless charging.
• Insert SD card with the pins facing down.
• Not compatible with Apple USB SuperDrive or CD Readers.
• USB-C ports do not support video output.
• Keep away from water, liquid, and moisture.